This tool is made to help with the filament bag suction process. I dreaded putting my filament back in the bags because it was a wrestling match every time. I was having to tip the spool and bag so the suction button was flat and I have a mats on my printer counters so it was hard to get a good seal. Just not enough hands (or patience) to make this easy.

This tool lifts the bag off the counter so the suction disc is easily accessed, it gives me flat spot to put the suction device on and the hole is big enough to fit on the “push pin” like holders for a skadis board. Filament bags managed!!

The offset in the handle has three purposes: 1.) to save filament, 2.) provides a wrist rest if using a manual pump, place your wrist on the offset handle to help hold the pump in place with one hand while operating the pump with the other and 3.) allows the tool will hang flat against the skadis board. Two key tops are included: heart shaped and ring. The spool holder is used only as a prop to show the offset, it is not included here.