Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.
Start with Black
At layer #15 (1.28mm) swap to Gray
At layer #21 (1.76mm) swap to Jade White
At layer #26 (2.16mm) swap to Red
At layer #30 (2.48mm) swap to Jade White for the rest.

_____________________________________________________________________________________

Michelangelo: https://makerworld.com/en/models/373860

Donartelo: https://makerworld.com/en/models/373858

Leonardo: https://makerworld.com/en/models/373854

___________________________________________________________________________________

If you like my work, please consider a small donation :) Thank you very much :*

https://www.paypal.com/donate/?hosted_button_id=RWRXKCAEM86K8