Modular Bathroom Vanity Organizer System by RHSJR0727

RHSJR0727

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

50.8 h

8 plates

5.0(1)

Boost

Released

Description

I created this Modular Bathroom Organizer for my Wife based on her request. It is stackable and you can print based on your needs. There are three different sized drawer assy's as well as two different types of toppers. The toppers can also be used as a stand alone organizer or tray depending on which one you print. The drawers are stackable in any configuration you want. I also included a catch so you don't accidently pull the drawer out of its shell.

bathroom

bathroom accessories

bathroom accessory

bathroom contest 2024

organizer

modular

drawer

Comment & Rating (6)

@mela.deavila

great design! I’ve had success printing the boxes but for some reason I cannot print the drawers. I’ve tried all 3 sizes, PLA, PETG, cool plate, textured plate in my X1c and cannot get past the first layer, nor even the brim. any tips on how to print these?

The designer has replied

@RHSJR0727

With the X1C, I'd Recommend turning the Aux fan to 30% or off. I run mine with the top glass open and the door open for PLA. On the plate, I've found that when I start having adhesion issues on the textured PEI, I wash with warm water and Dawn soap in the sink. Then dry with paper towel and wipe with 99% IPA. I also wipe with 99% IPA after every print.

@mela.deavila

Replying to @RHSJR0727 :

I also printing with top off and door open, also have cleaned the plate with dawn then alcohol on textured plate, on cool plate just dawn. I’ve also turned off the aux fan. are you slowing your speeds down considerably for the first layer? what about ortientation of model on the plate?

@RHSJR0727

Replying to @mela.deavila :

I printed the model as it was loaded to maker world. Standard settings for .2mm height .4mm nozzle. Gyroid is the only thing you should need to change from the standard settings for the drawer inserts. I run tree supports on auto. Are you trying to print from your phone or your computer? I know there was a firmware update recently for the X1C? The drawer inserts and toppers should be laying flat, the shells stand up on their backs.