Honeycomb Windmill Pole Extension Remixed by daniel.fiorica

Remixed by

daniel.fiorica

Education>Physics & Astronomy

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

51 min

1 plate

5.0(2)

Boost

Released

Description

I created a simple extension pole for the Honeycomb Windmill. It also works with the Torodial Windmill and Windmill Base clamp that were all created by user BamBam Design.

The male part of the pole may need some post-processing to ensure a smooth fit. It must be printed diaganolly to fit the print bed (on P1 and X1 series). I was able to fit 3 on the print bed at one time.

Comment & Rating (6)

@BamBamDesign

Cool 😎 Nice Windmill and nice addition 🤝

The designer has replied

@daniel.fiorica

Thanks! love the design you made. I was thinking about doing a remix to the windmill frame piece so it can rotate 360° as the wind turns. were you planning on something like that?

@BamBamDesign

Thank you! Normally it should turn/ adjust to the wind. Mine 3 all works fine. Did you printed the rod vertical, original orientation in the print profile? The L formed Shaft should spin freely in the rod.

@daniel.fiorica

I think I printed vertically but I can't recall. I'll reprint, thanks!