I created this model with the intention to be a bit different than other UNO cards boxes. Due to its somewhat larger size, it is also suitable for many other games involving cards. You are allowed to share adaptions of this model as long as you reference the original designer (me), thanks :). No Commercial use allowed. If there are any problems with the model, please leave a comment and I will try to reply as fast as I can.

This model can be printed without supports, exept from the little latch on the top part (minimal supports). Recommended settings: 0.2mm layer heights, 20% Infill and no supports (exept for the latch on some printers). The hinge is made from a +/-60mm long M4 bolt, but could be replaced by a 3Dprinted shaft.