Dial Gauge Holder 8mm for print bed adjustment
Messuhrhalter für 8mm Schaft, um das Druckbett optimal zu nivellieren.
Achte darauf, dass nicht zu viel Vorspannung auf der Messuhr ist und du ein glattes Druckerbett ohne Druckbetthaftung Kleber verwendest, da sonst die Messuhrspitze nicht beim verfahren auf der Fläche gleitet. Nutze eine Messuhr mit Kugelspitze!
Zum Justieren die Punkte vorn links, vorn rechts und hinten Mitte auf gleiches Level einstellen.
***
Dial Gauge Holder 8mm for print bed adjustment
Dial gauge holder for 8mm shaft for optimal leveling of the print bed.
Make sure that there is not too much pre-tension on the dial gauge and that you use a smooth print bed without print bed adhesive, otherwise the dial gauge tip will not slide on the surface when moving. Use a dial gauge with a ball tip!
To adjust, set the front left, front right and rear center points to the same level.
PLA
Layer: 0.12
Wall: 4
Fill: 25%
Support: NO