Enlarged to 240mm wide from cyanidesugar's original, licensed CC-BY-NC-SA: https://makerworld.com/en/models/53373
This is a +35% increase, but note the HueForge portion is only enlarged in 2 dimensions, not 3, to maintain the same appearance. The Falcon is enlarged in all 3 dimensions.
This uses 0.08mm layer height for better detail on the Falcon, a change from 0.16mm.
An original stand is included to display the print at a 45 degree angle. There are two “pockets” in the stand behind the print that can be storage. Model link: https://www.tinkercad.com/things/j1OyL21tfhH-hueforge-millenium-falcon-stand
Swap Instructions:
- Start with Burnt Titanium, Black, or another dark color.
- At layer #7 (0.68mm), swap to Teal.
- At layer #11 (1.00mm), swap to White.
- At layer #25 (2.12mm), swap to Grey (this is the Falcon!).