Star Trek TNG uniform shirt fridge magnet
Boost
54
57
15
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Boost
54
57
15
1
47
17
Released
Description
Star Trek TNG then next generation series uniform shirt fridge magnet
(Original series available here https://makerworld.com/en/models/207276#profileId-227383)
For the Shirt print the base in black then choose the colour of shirt you would like Red, Yellow or Blue (Or print all 3….or an entire landing party!)
In Bambu studio in the objects view there are 4 insignia objects colour these gold, black of delete them as you wish to generate the various ranks of the crew.
The shirt takes 2x 6mm diameter by 2mm deep magnets that push in after printing.
Live long and prosper everyone!
Comment & Rating (15)
All
Print Profile
0.12mm layer, 2 walls, 15% infill
wonderfull, put a pin on the back to wear it on a shirt
The designer has replied
1
Reply
Nice idea! And thank you for the rating
(Edited)1
Reply
love these, thank you for making them!
Now, about Lower Decks…..
The designer has replied
1
Reply
Thanks for the support,
And.... 😂 Maybe...
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
has surface quality issues on most pieces, but one out of 6 on the plate was perfect. Not sure if this profile and my filament just disagree though
(Edited)
The designer has replied
0
Reply
I'm sorry they didn't turn out right for you, the top surface should be smooth... I agree it may be the filament you used perhaps
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
printed absolutely wonderfully
The designer has replied
1
Reply
Pleased you like the model, thank you for the rating I appreciate it
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Dots print inconsistently for me. More tweaking to try...
The designer has replied
0
Reply
I'm sorry you're having trouble with the dots... Are you using a .4 mm nozzle?
Later today or maybe tomorrow I'm going to increase the size of the dots a little bit as you're the second person who has had trouble.
(Edited)0
Reply
Replying to @crabstiks
Yes 0.4 on the X1C. It’s a problem here not the file so I rated 5 stars. I will be retrying in my A1 Mini with 0.2. It might even be the yellow filament that isn’t laying and retracting for the dots well enough.
(Edited)1
Reply
Wonderful! Those dots though are super difficult to print for me... even on X1C and A1 Mini. Trying to slow it down a lot...
The designer has replied
1
Reply
Oh! They print fine for me on a p1s, sorry you're having trouble
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
bought little magenets for them and the wife loves them!
The designer has replied
0
Reply
Thanks for the rating, I'm pleased you like them :)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld