Simple screwable easter egg. Perfect for small objects to hide for the easter season.

The inside is hollow with a minimum diameter of about 3 cm / 1,18 in at the center. In the top and bottom half the diameter gets a bit bigger after the thread. The first screws are a bit stiff but after a few times it should open and close smoothly.

Size:

• Height: about 7 cm / 2,75 in
• Width: about 5 cm / 1,97 in

Material: I printed this in PLA and it worked perfectly fine, other materials should work as well but are not tested so far

Support: Yes, you can customize the support structure if you want however I found the default support to be working just fine.

Printer Settings:

• Layer Hight: 0,2 mm
• Layer Width: 0,4 mm