HO229 Based Twin EDF Flying Wing
Copyright Claim
HO229 Based Twin EDF Flying Wing
Boost
10
17
2
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
1.4 h
1 plate
Boost
10
17
2
0
36
5
Released
Description
Horton 229 Inspired design, uses a split aileron system that acts as both ailerons, vertical and horizontal stabilisers. Designed for twin EDFs.
Note: This aircraft needs to be wrapped which is why it has a hollowed out fuselage.
Comment & Rating (2)
All
Love the Horten Ho 229.
My print profile above leaves the "bottom" a bit thin. I'd scaling the print as large as you can on the bed and lowering the layer height to get a better quality print.
I also split another version of the model down the fuselage to print two halves facing up but, a lot of supports are required.
This was a quick print at 0.20
The designer has replied
2
Reply
Thankyou for your review!, i uploaded some images of the model on reddit and with some advice on what airfoils to use, I have allmost completed a next flying wing.
2
Reply
No more
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld