Looking for a nice gift for a birthday? I designed this cupcake ornament just for these cases. It has a 0.3 in hole for any string that you favor using to hang this up or flip it over and use it as a coaster!!!
I used a 0.2mm layer height on this and it looks pretty good. The bottom has some red on it because I had to purge out some red filament stuck in the Bowden tube of my Ender 3 Pro. My infill settings are also a bit low (6%) hence the poor surface finish.
It took around 2-3hr to print. Probably cut in half by Bambu printers or just general Klipperized machines.
Enjoy the model and I wish whoever you give it to a happy birthday!!!
----------------------------------------------------------------------------------------------------------------------------------------------
Check out how I photographed the coaster!!!