!! You can remix the bottom piece to attach to a piece of MDF on the bottom, wider printed base, or different sized monitor heights. Check remixes to see what other people have done, or post your own.

I have two 34inch ultrawide monitors, and I wanted them stacked on top of each other. I hate using those janky gas strut stands which get bumped out of place really easily. Also works perfectly for 27inch non ultrawide monitors without any modifications. Would work for smaller monitors without modification but with gap below.

This is a simple two part stand that can hold the weight of the monitor (you can lift the monitor using the stand), the design was supposed to use the bottom edge of the monitor as the weight bearing face but i guess a calculation went wrong because the monitor hovers about 1cm off the desk.

The base is wide enough that the entire monitor balances on it without tipping or rocking.

I used 8mm spaced gyroid infill, 3 walls and its really solid. There is provisions for 6 M4 bolts to hold the two pieces together but my printers tolerances were enough to only need 2 screws to prevent seperation. Although I ended up using 4 just for sanity sake.