Adjustable graphic card holder bracket AMD
Copyright Claim
Adjustable graphic card holder bracket AMD
Boost
24
22
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Boost
24
22
2
1
48
12
Released
Description
- Print per object is set in the profile.
- A support blocker is set on the threaded rod.
- The AMD needs the support, it takes 2 minutes to get the inside out nicely. You will need a large screwdriver, a small screwdriver and a small pair of pliers. Wait until the object cools down and be careful!
- The AMD is rotated 180 degrees on the Y axis, so the bottom becomes the front of the object, and so you don't see the seam in the middle of the rod as it is on the back.
- I have tested it, I have printed several pieces.
- Adjustable between 88 and 134 mm.
- If you like it, please give it a like and a drop a review if you printed it.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
© 2024 MakerWorld