This is a dactyl manuform 5x6 that I have fabricated and made. It has 6 3D printed parts in total. For more coding information you can visit my GitHub Repository which has a lot more detail on the coding side of things.
[GitHub](https://github.com/IoakeimSogiakas/dactyl_manuform_5x6-ZMK)
This keyboard was designed to work well with the following parts from Alliexpress.
The holder file is the one where you place the microcontroller, the battery (now that I have made this I would advise going with a bigger one than the one listed) an on-off switch, and a push button for flashing.
The links are the following:
Micro-controller
The battery (mind you, you need two one for each half)
https://www.aliexpress.com/item/1005005796773290.html?spm=a2g0o.order_list.order_list_main.23.438a1802IiRg7R
And the switch (the SS-12F15 version which when you install it you need to cut the screw tabs and glue it in place I used CA glue)
https://www.aliexpress.com/item/1005006035957341.html?spm=a2g0o.order_list.order_list_main.17.438a1802IiRg7R
Lastly, the halves consist of a top part where everything is sited and a bottom cap.
For this you will need mx still switches I went with these (you need 70 of them) which I hand-lubed
https://www.aliexpress.com/item/1005002511539824.html?spm=a2g0o.order_list.order_list_main.59.28a61802QZWmnU
Some generic 1N4148 diodes like these and some wire to connect everything
https://www.aliexpress.com/item/1005003540554760.html?spm=a2g0o.order_list.order_list_main.54.438a1802IiRg7R
And lastly a keycap set I had a great time with this one
https://www.aliexpress.com/item/1005004537134105.html?spm=a2g0o.order_list.order_list_main.49.438a1802IiRg7R