Motion Sensor Attachment for Diana Foam Blaster

This simple motion sensor will pre-rev the motors intuitively. When you holster the blaster, the motors will stop automatically, no special magnetic holster is required to turn off a reed switch installed on your Diana blaster.

Build Video: https://youtu.be/WIZnTppaalk

In short, these upgrade parts (when completed with the hardware listed below) will perfect your Diana 'Nerf' Blaster by:

1. Allowing you to attach a "Worker" (brand) SCAR for accuracy. 2.Allowing you to turn on/off your blaster without having to remove the battery cap every time. 3.Automatically pre-rev the motors for you and automatically turn off the pre-rev if you holster your Diana blaster or when you place it on a table or floor (this motion sensor function can be turned off via the existing mode switch when you do not want any pre-rev at all, eg: when playing the role of a sniper).

Hardware required to use with the 3D printed parts:
3 x mercury switches (3mm diameter)
2 x 28awg or thin wires (non-stiff) which are 22cm in length
2 x 24awg wires (non-stiff) which are 10cm in length
2 x micro deans connectors
4 x M1.5 screws which are 5mm in length
4 x M2 screws which are 15mm in length
1 x Optional 'Worker' Scar to attach to the 3D printed muzzle.

All hardware parts are available at Aliexpress other than the 'Worker' SCAR.

30% infill (ABS or PLA)
no support required