Do NOT adjust the thickness (Z) in your slicer!! The layers will not come out right. You CAN adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.
These were my settings and colors for my print that you see in the picture. Your results may vary depending on the filament you use and if you have your own HueForge profile saved with different settings.
This is a long print without a Height Range Modifier (11.5ish hours). If your slicer has the capacity to do a height range modifier and you want to cut some time off, add one! The “Swap Instructions” below are for without a height modifier.
Height Range Modifier Instructions (if your slicer is capable):
You will want to add a height range modifier to the object of 0-1.44, with a layer height of 0.16 mm.
The “Swap Instructions” listed below will not match up for the layer number listed, but the mm listed for each is still accurate and correct.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
Nozzle: 0.4
Filaments Used:
PLA Sunlu Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 5
PLA Sunlu Gold Transmission Distance: 5
PLA Sunlu White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #44 (1.88mm) swap to Red
At layer #48 (2.04mm) swap to Gold
At layer #50 (2.12mm) swap to White for the rest
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.