Toy Gear shifter
Copyright Claim
Toy Gear shifter
Boost
29
30
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
7.3 h
1 plate
Boost
29
30
6
1
133
65
Released
Description
This is a fully 3D printed Gearshift toy with only snap-fit parts and a bit of glue!
I didn't like how other shifters I could find worked so I decided to make my own!
I recommend printing the knob a different color for more pop.
Print setting where low layer height for knob and higher for fast printing for the rest. Supports are only needed for the knob, depending on your orientation.
Instructions
Glue the shifter bar onto the shifter base.
Snap the shifter rotator onto the bar and the base.
Glue the cover on
Glue the knob on.
Obviously inspiration is taken from other creators, so thanks to them.
If you want to help me continue to create designs like this, Buy me a Coffee!
https://www.buymeacoffee.com/alphavia
Comment & Rating (6)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
very good, the ball was hard to print, it kept falling but it eventually worked when i painted the supports
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
amazing print just wish the knob was a little bigger.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld