heart candle tree
heart candle tree
Boost
30
32
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.5 h
1 plate
Boost
30
32
4
0
41
27
Released
Description
i made this but not realising till it was half printed that i put the bottom 1 and top 1 right in the same line lol
so this is for FAKE!! battery powered candles ONLY!! but you can put normal candles in the middle and the top still
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Die konstruierte Datei wurde mit niedriger Auflösung als Stl exportiert und daher sind die Rundungen nicht rund, sondern eckig. Zusätzlich ist der Support nicht so gut positioniert.
Das kann noch ein gutes Modell werden. also weiter so! :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
The designer has replied
0
Reply
definitely not too thin, I can pick the whole model up and turn it on its side and the hearts don't snap. for yours to just fall off when you touched it that's just user error. see the pic I attached
(Edited)
0
Reply
Replying to @Fatalchaos25
I'll print it again, also with other filament, hope it's going to work then :)
0
Reply
No more
License
This work is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld