Skadis Stand
Copyright Claim
Skadis Stand
Boost
88
171
29
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Boost
88
171
29
0
289
158
Released
Description
Introducing the "Skadis Stand" – the sassy and stylish solution to elevate your IKEA Skadis pegboard game to new heights! Crafted with precision using the wizardry of 3D printing, these quirky appendages transform your humble pegboard into a majestic masterpiece.
Check out my Other Skadis Stuff in my Profile!
skadis
office
office accessories
desk
desk accessories
seperator
desk seperator
ikea
workshop
workshop organization
workshop organizer
workshop accessory
organizer
office organizer
desk organiser
shop
garage
garage organizer
garage organization
kitchen
kitchen accessories
kitchen accessory
kitchen organizer
buero
werkstatt
lochrasterplatte
pegboard
peg board accessories
pegboard mount
pegboardadapter
clean
tidy
living
Comment & Rating (29)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
fixed! thank you for your hard work.
(Edited)The designer has replied
1
Reply
Ok can you tell me what the problem was? The screws were fine for me.
0
Reply
Replying to @Poldion
So without the skadis board, it does tighten. But with the board the screw just doesn’t seem to go into the thread. Not sure if it’s too short? It’s a new skadis board.
0
Reply
Replying to @Poldion
On review, the screw does tighten when there is no board attached but not all that much.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
brilliant, very sturdy
The designer has replied
0
Reply
thank you
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
awesome print, perfect
The designer has replied
0
Reply
Thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
comodissimo
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Bed Adhesion Issue:fixed later
The designer has replied
0
Reply
Hatte das Haftungsproblem mit dem Profil zu tun?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld