Remote Holder RGB
Copyright Claim
Remote Holder RGB
Boost
27
41
21
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
34 min
1 plate
Boost
27
41
21
0
98
147
Released
Description
Holder for a RGB Remotecontrol. Glued it with tape to the wall.
Quality on the picture is caused by my old printer.
Printed it in PETG but PLA should be possible as well
Comment & Rating (21)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
très utile
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
daughter loves her 2 i printed out for each of her night light remotes
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
mega praktisch
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
passt nicht für meine Fernbedienung
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Simple but perfect
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
does the job i just had to scale it up slightly
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
mis a part mon plateau qui n’était pas bien dégraissé , le fichier est très bien .
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld