p1s-front-dash-with-Xtouch-screen
Remixed by
Copyright Claim
p1s-front-dash-with-Xtouch-screen
Remixed by
Boost
38
62
23
Print Profile(3)
0.2mm layer, 3 walls, 15% infill
Designer
2.2 h
1 plate
0.2mm layer, 3 walls, 15% infill
Designer
2.4 h
1 plate
0.2mm layer, 3 walls, 15% infill
Designer
2.4 h
1 plate
Boost
38
62
23
0
155
73
Released
Description
wanted to add xtouch screen to p1s and hide the cable through riser
the case for the xtouch was from YouTube Teaching tech https://www.printables.com/model/611634-xtouch-enclosure-for-bambu-lab-p1ps
V2 clean look changed cable entry.
Added P1P front dash with usb cable track
11/19 Added Right dash for button badge insert
Just uploaded a micro sd card button for the blv ams riser
https://makerworld.com/en/models/62302#profileId-64849
Comment & Rating (23)
All
Love it! Can you possible make the right side with how it is on X1 with the whole cut out? My Bambu's are all droids and I used it to put the tag.
The designer has replied
1
Reply
ok will do
0
Reply
its up and loaded for you enjoy
2
Reply
Replying to @Big.Daddy.
Is this model with a hole on the left and the right still available? Sorry I'm new to this and can't seem to find it. thx!
1
Reply
How did you get the bracket of the casing to fit on? For me it hits the front dash of the AMS riser and is no where close to fitting.
The designer has replied
1
Reply
If you need a spacer you can use this https://makerworld.com/en/models/49439#profileId-51313
1
Reply
that spacer is also design to take the usb cable to but you would have to trim down the end of the usb cable or take circuit board out to get it in. but you can use it for a spacer to get clearance from the dash
0
Reply
Replying to @Big.Daddy.
Alright, thank you so much!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1a passen besser als die originalen. die t-nut hält sogar von selber nicht wie bei den originalen
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld