This is a modification to the BPNVG v2 (Original v1 here: https://www.thingiverse.com/thing:4769287, v2 is distributed on DC - but you know that if you're here). Out of respect for the author, I am not providing the complete set of files here (despite the model being distributed on DC without a license), only the ones that I have modified for this purpose.

This mod allows you to print everything FLAT. This significantly increases quality and decreases the supports needed.

Furthermore, it allows you to combine individual monocle housings to form binoc halves of the pano setup.

I have also reduced the peripheral viewing angle from 45 to 30, which is helpful with narrower angle lenses (considering that the Runcam is unobtanium).

• Runcam Night Eagle 2 Pro = 140* FOV
• Foxeer Nightcat 3 Starlight = 100-125* FOV

  Changelog

v1.1

• Modified sensor housing to accept a Micro FPV Cam (I used the Foxeer Night Cat 3)
• Modified LCD board mount to allow for screw/glue-less mounting of Adafruit board
• Modified LCD panel mount to print cleaner flat
• Modified Binoc coupler to allow power wires to pass through the gasket spacer and to the exterior of the unit
• Modified gasket space to allow for mounting of LCD and board without glue
• Built pano bridge with buffer-based system to adjust IPD when using two mono housings

• Added Binoc lens retainerFurther planned enhancements:

• 850nm infrared emitter mount embedded monocle bridge

• Power-chainable monocle housings
• Revised, angle-adjustable pano bridge

  Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Filament:
Any Any Black

Category: Sport & Outdoors