Have fun with this Nintendo Switch Dock Cover. This cover is for the “normal” Switch Dock, I don't know if the OLED-Dock is different.
If your printer and filament is dialed in it should slide right over your dock.
To ensure you waste as little filament and time as possible I added a small test piece on a second plate. If needed adjust/scale it by a tiny amount according to your tolerances or filament.
All my prints use Sunlu PLA +.
A first layer and first layer infill speed of 25mm/s, only one wall on first layer and a first layer line width of 0.25mm at a nozzle size of 0.2mm.
See my other designs:
0.4mm Nozzle
0.2mm Nozzle
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.