Matco Tool Grid Mounts/Pegs/Holders/Boards
Copyright Claim
Matco Tool Grid Mounts/Pegs/Holders/Boards
Boost
27
56
7
Print Profile(3)
PETG 0.2mm layer, 4 walls, 30% Gyroid infill
Designer
2.1 h
1 plate
PLA Pro 0.2mm layer, 4 walls, 30% infill
Designer
1.6 h
1 plate
seperated parts
4.2 h
11 plates
Boost
27
56
7
1
134
80
Released
Description
ONLY USE DESIGNER PROFILES
(TWO HAVE BEEN PROVIDED PETG AND PLA PRO)
These are all of the Gen 1 Matco Tool Grid(Mantis Tool) pieces including grid board prints from 50mm to 220mm. It is a total of 11 parts/ pieces. You will need to either print the boards using the supplied files or purchase the base boards from Matco or Obsessed Garage. Also you'll need screws to attach the pieces to the board, those can be found on Obsessed Garage or Amazon.
Comment & Rating (7)
All
do you have the actual grid file too? or just the tool holders? Also do you know any ideas to get the rubber pad in the tip and handle holders?
(Edited)
0
Reply
Any chance these can be made available for the A1 mini?
thanks
0
Reply
Print Profile
PETG 0.2mm layer, 4 walls, 30% Gyroid infill
0
Reply
Print Profile
seperated parts
0
Reply
Print Profile
PETG 0.2mm layer, 4 walls, 30% Gyroid infill
0
Reply
Print Profile
PLA Pro 0.2mm layer, 4 walls, 30% infill
0
Reply
Print Profile
PETG 0.2mm layer, 4 walls, 30% Gyroid infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld