Another UNO card box
Copyright Claim
Another UNO card box
Boost
51
86
43
Print Profile(1)
0.2mm layer, 5 walls, 15% infill
Designer
1.8 h
1 plate
Boost
51
86
43
2
284
346
Released
Description
Material does not matter. I used PLA, printed 0.2LH, 4 walls/top/bottom layers, 10% infill.
There is also a STL without the handle.
PLEASE ORIENT THE MAINBOX UPWARDS :
Comment & Rating (43)
All
Print Profile
0.2mm layer, 5 walls, 15% infill
excellent container...easy and fast print to store playing cards 💪🏻👍🏻
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
Alles gut danke
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
it’s a very tight fit for a entire pack but I like it. printed perfectly.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
This is perfect! It slides in and out very well. worth the print!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Looks nice. Fits perfect together. I like it.
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
just did not work on my a1… not sure why. ended up with a ton of spaghetti
The designer has replied
0
Reply
Reason is probably with a not so clean bed.
Too bad for a 1* rating for a clearly not fault file as it been printed quite a few times already...and its 2 basic boxes.
0
Reply
Replying to @Rangebear
Bed was absolutely clean. I’ll give it another shot though and will update my review accordingly. Thanks for taking your time though!
0
Reply
This file is perfection. I'm curious if the author has the file without the word uno on it so I can adapt it to my other card games.
The designer has replied
0
Reply
Glad you like it. Uploaded the .step file for you. Just extrude the UNO LOGO section to even out with the surface and your good to go. Enjoy :)
0
Reply
Replying to @Rangebear
Great! Thanks
for your contribution!
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
the size was a bit off
The designer has replied
0
Reply
weird , the the size been good for all so far, not sure what went wrong. :)
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
Lies sich super drucken. Passt perfekt
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
they don't fit into each other and needs supports adding.
The designer has replied
0
Reply
They do not. You did not orient them right.
The right way is :
(Edited)
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld