This is a battery holder for the Bambu Spool Weight from LarryCnAZ, link below:
https://makerworld.com/en/models/72331#profileId-76531
Since I don't want any moving parts as spool weights, this holder was designed to hold up to six AA batteries and press them against the housing wall without moving.
I printed the part with a Bambu Lab P1S, 0.4mm nozzle, layer height 0.2mm from PLA.
First insert the six AA batteries into the housing, then insert the battery holder. Align one battery after the other and press the holder down slightly.
Thank you for the like and download.
Dies ist ein Batteriehalter für das Bambu Spool Weight von LarryCnAZ, Link unten:
https://makerworld.com/en/models/72331#profileId-76531
Da ich keine beweglichen Teile als Spulengewicht haben möchte, wurde diese Halterung so konzipiert, dass sie bis zu sechs AA-Batterien aufnehmen kann und diese an die Gehäusewand gedrückt werden ohne sich zu bewegen.
Ich habe das Bauteil mit einem Bambu Lab P1S, 0,4mm Düse, Schichthöhe 0,2mm aus PLA gedruckt.
Zuerst die sechs AA-Batterien in das Gehäuse einlegen, dann den Batteriehalter einsetzen. Richten Sie eine Batterie nach der anderen aus und drücken Sie den Halter etwas nach unten.
Danke fürs Like und den Download.