Halloween Pumpkin - LED Tealight holder - Jack o lantern
Copyright Claim
Halloween Pumpkin - LED Tealight holder - Jack o lantern
Boost
89
145
25
Print Profile(10)
Model 1 - 0.16mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
All designs on one plate - 0.16mm layer, 2 walls, 15% infill
Designer
12.2 h
1 plate
Model 5 - 0.16mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Model 2 - 0.16mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Click to see more
Boost
89
145
25
0
345
201
Released
Description
Jack o lanterns scaled to fit LED tealights for amazing decorations for halloween.
There are 6 different models available for printing.
The lid fits all models.
New printer profiles added for quicker printing with less filament use.
There has also been added print profiles for the models in 200% scale.
Make sure to remove the support inside the lid so that the model closes properly.
There are print profiles available per model and all together.
I would recommend using LED diffuser over the led tealights to soften the light. Model for Led diffuser can be found on my profile uploads.
Comment & Rating (25)
All
Fantastic design and easy to print!
The designer has replied
1
Reply
Thanks mate :)
I love that you have printed the LED diffuser as well. It gives the extra glow and pop instead of the direct light from the LEDs.
0
Reply
Print Profile
All designs on one plate - 0.16mm layer, 2 walls, 15% infill
Opening wasn't big enough for tea lights.
The designer has replied
0
Reply
Then you might have larger than normal sized LED tealights.
The models scale well, so you can just resize them a few percent to fit your tealight size.
0
Reply
Print Profile
All designs on one plate - 0.16mm layer, 2 walls, 15% infill
Kids loved them
1
Reply
Print Profile
Model 2 - 0.16mm layer, 2 walls, 15% infill
super 😃👍
1
Reply
Print Profile
Model 1 - 0.16mm layer, 2 walls, 15% infill
Prints perfectly, supports fall away like dandelions, glows beautifully and they make awesome decorations for a small space!
1
Reply
Print Profile
Model 6 - 0.16mm layer, 2 walls, 15% infill
I printed it from natural PET and it does not look very well, but from orange filament it looks good.
0
Reply
Print Profile
Model 1⭐𝐅𝐚𝐬𝐭 ‣ 0.2mm layer, 2 walls, 3% infill
The print was OK, was a nightmare getting the supports off the lid, the walls are quite thick themselves which makes it a kind of length print to make other than that no issues
0
Reply
Print Profile
Model 1 - 0.16mm layer, 2 walls, 15% infill
wow amazing. using tree support the results is amazing
0
Reply
Print Profile
All designs on one plate - 0.16mm layer, 2 walls, 15% infill
very hard to remove the supports, items didn’t look very good
The designer has replied
0
Reply
which filament did you use?
0
Reply
Print Profile
All designs on one plate - 0.16mm layer, 2 walls, 15% infill
Very well designed! Thank you for sharing!
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld