Secret Stash Soda Can with Hidden Compartment by calsynergy

calsynergy

Tools>Organizers

Print Profile(3)

All

P1P

P1S

X1 Carbon

X1E

Faster and Less Waste Print by Object

Designer

3.2 h

1 plate

5.0(1)

0.2mm layer, 3 walls, 10% infill

Designer

6 h

3 plates

4.8(8)

0.2mm layer, 3 walls, 10% infill

Designer

4.9 h

1 plate

4.7(3)

Boost

106

164

150

Released

Description

UPDATE 02/09/2024: I added a new print profile that is print by object. Not only does it print a lot faster, there is a lot less waste because of less filament changes. Please check it out!

If you have extra free BOOSTS and want to support, I'd be humble to take a donation. Check out all my other products such as keychains and Taylor Swift goodies on my profile page. Thanks and enjoy!

This is a Secret Stash Soda Can for hiding your valuable belongings. This is perfect for your car, backpack, refrigerator, and more. I hope you guys enjoy it and please let me know what you guys use it for.

I printed this in PLA+

Printed in 0.20mm
3 Wall Loops
4 Top Shell Layers
4 Bottom Shell Layers
10% Infill
This is also colorized for those with AMS
NO SUPPORTS NEEDED

You will need to print the following:

Top of Stash Can
Bottom of Stash Can
And your choice of a Middle of Stash Can Full Opening with single compartment, or Middle of Stash Can with Hidden Compartment. The hidden compartments has an extra hidden compartment below.

Please like, share your makes, and remix. Would love to see what the community can do!

Comment & Rating (14)

@MacsP1S

Print Profile

0.2mm layer, 3 walls, 10% infill

very nice. printed from my phone remotely, came home a few hours later and it was complete. great quality and screwed togwther with no issues

The designer has replied

@calsynergy

Thanks for printing it out and sharing your picture! Love the color combo

(Edited)

@funkyfresh3d

good one! Thanx! Is there a way to have this with one compartment so it can fit lots of money? Also smooth walls would be nice as well

@BlueFish

Print Profile

0.2mm layer, 3 walls, 10% infill

Works Good 👍

@ajamiano55

Print Profile

0.2mm layer, 3 walls, 10% infill

Great outer shells. It got messy on the inside of the hollow model and the underside if the lids are very stringy. I used a heat gun to smooth out the inside lid.