USB-C Step-Up Module Case - MT3608
I modeled the case for the need for a 12V LED - Bambu Lab A1 LED Light Bar, including a small switch
powered by a regular 5V USB charger
I bought the USB-C step up on Ali - TYPE-C MT3608 DC-DC Adjustable Boost Module 2A Boost Plate Step Up Module with/without MICRO USB 2V-24V to 5V 9V 12V 28V - AliExpress
The lid just clicks (if it's loose, rough it up, not a drop of glue)
Carefully insert the module all the way to the bottom, it should not move afterwards.
There is an opening on the side for voltage regulation
The cable hole has a diameter of about 4mm
PLA or PETG
It does not need supports
Please share your print
link
Bambu Lab A1 LED Light Bar
https://makerworld.com/cs/models/133385#profileId-144663