A1 Top Mount accessories can be found at A1 Top Mount Accessories Rev 2 by Jeff Smith - MakerWorld. There are also Wyze camera mounting options using the Top Mount which can be found at A1 Wyzecam Mounts Rev 2 by Jeff Smith - MakerWorld
Update: 1/4/2023 - Added toolboxes to the accessories as well as a clipper hanger option. There are 2 variants of the toolbox. 2 can be printed on the A1 Mini (~150mm) and 2 that are too large and need to be printed on the A1 or similar size plate.
*** Be careful to make sure whatever combination of post, loop, etc. you put together (various options you choose) has clearance of the z-axis and the extruder at all points in a print. IE - manually move it around to check clearances.
Thanks to A1 mini handle by LwFactory - MakerWorld for the handle, and the connection point/measurements came from the ams-lite top-mount at A1 MINI AMS TOP MOUNT / RISER - ONE PIECE Remixed by Spar-Fuchs24.de - MakerWorld
This is the 3rd revision which greatly simplifies everything and adds a handle to lift / carry the Mini.
I've also added a floating arm/post with loop as shown in the pictures. As designed/printed it's a little stiff so doesn't just flop around, you can change the width of the model by 1-2mm and it will float loosely.
Instructions:
Pick the Top Mount that works for you, and print either a long, or short post with a loop. There are also optional plugs in the event you want to print the multi-hole version and just plug the ones you don't want to use. (printed the plugs in draft, so they aren't quite clean in the picture below).
Each plug has a letter on the flat side, which corresponds to a hole in the mounts.
Note, do not change the orientation of the plugs on the plate in the .3MF as you only want the flat rounded portion to touch the plate.
If you have questions or concerns, leave me a note here or on Bambu4all on FB.