Print Profile(1)
1 set, 0.2mm layer, 2 walls, 15% infill
49 min
1 plate
Boost
29
45
11
0
91
80
Released
Description
This is a very simple garden gate latch, easy to print, easy to install.
To assembly it, you will just need hardware mentioned below.
I recommend using locking glue to secure the bolt and nut over time, and to grease the “bearing”:
Print instructions
- Print in PETG or any other outdoor suitable material
- No supports needed
- Print with 4+ perimeters
Additional hardware needed
- 1x M4x18 bolt
- 1x M4 nut
- 3x screws
Optional
- Locking glue
- Grease
Comment & Rating (11)
All
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
It turned out nice but... 15% infil is not realy structuraly solid. It bends a bit to much for my liking.
(Edited)
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
thank you for the file, it printed perfectly
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
good design a simple and light cost.
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
Simple and strong. Does its purpose well.
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
1 set, 0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld