Before Pops got big, there were Mighty Muggs. They suffer the same big head, little body syndrome as their successors and are prone to falling over in a stiff wind. I got tired of that happening with my collection and threw together a base/stand that will lower the chances of them tipping over and possibly getting damaged.

There is an arrow on the top of the peg that is meant to point towards the front of the Mugg. Once you have things lined up, a gentle push and you should hear/feel a soft click as the peg seats into the foot.

Included are three files:

• Test print: Very minimal and only intended to check that the peg lines up right for your Mugg.
• 1mm: Low profile stand. I found it to be too flexible to really do a good job but some might prefer the aesthetics so I uploaded it.
• 3mm: Just enough thickness to remove flex and keep your Mugg from wobbling.

I kept it simple and only focused on the stock Mugg. Feel free to customize as you see fit! Shouldn't be too hard to add name plates, etc.

Disclaimer: Please be gentle and use care when removing, or the peg will break off in the foot of your Mugg. I also do not recommend printing in silk filament - it looks great but it's too fragile.