Robo-Lamp
Robo-Lamp
Boost
29
51
5
Print Profile(2)
Part-1-0.2mm layer, 2 walls, 15% infill
Designer
4.9 h
1 plate
Part-2-0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Boost
29
51
5
0
27
1
Released
Description
Be careful with assembly. It could be that the connectors break - but I had no problems with PLA Tough
It would be better if you print the connectors horizontal.
I used a Philips Hue bulb with an E14 fitting. This means that the lamp does not need an on/off switch.
Comment & Rating (5)
All
here it is 😊🥳
The designer has replied
1
Reply
Thx for sharing! So nice! 🤩
0
Reply
my son love it! so me too. 😊👍🏻
The designer has replied
0
Reply
So nice your son love it.
I just printed a new one and painted it nicely.
I hope I'll finish it tomorrow. :-)
It would be nice if you could share your results
(Edited)1
Reply
Replying to @StefanHeer
nice paintjob! I like it!
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld