Bambu X1/P1P/P1S Side Filament Holder - Bottom Feed
Remixed by
Copyright Claim
Bambu X1/P1P/P1S Side Filament Holder - Bottom Feed
Remixed by
Boost
3
1
0
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
2.1 h
1 plate
Boost
3
1
0
0
4
1
Released
Description
A remix of Steve Wagg's Bambu X1/ P1P / P1S Horizontal Side Filament Holder that feeds the filament from the below the spool instead of above it. This makes it easier to route the PTFE tube into a Y splitter without an extreme bend radius.
The PTFE tube wasn't very secure in the holder (identical to the original), so I just tapped the hole and screwed in a PC4-M6 fitting.
Comment & Rating (0)
All
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld