Rubix Cube Tissue Box Cover for Single Color Printers
Rubix Cube Tissue Box Cover for Single Color Printers
Boost
39
73
6
Print Profile(1)
Multicolor Cube Upside Down with PETG Supports- 0.2mm layer, 3 walls, 15% infill
14.5 h
5 plates
Boost
39
73
6
3
61
38
Released
Description
Heads up- once inserted color tiles don't want to come out again, I almost hurt myself.
You are going to set a Filament color change @ 135.2mm. Switch from black to whatever you want top tiles to be. Then add the 4 side color tiles. It doesn't have to be solved- make it 1 away to mess with people.
Main cube will need some supports, check out the 3mf for custom painted ones.
Use these with organic supports to make it as fast as possible. Holes on outside do not need support.
Comment & Rating (6)
All
How did you remove the supports cleanly on the squares that are on the top of the box? They do not break away easily and leaves a lot of residual material once removed.
The designer has replied
0
Reply
I printed it top side up with supports on the inside
1
Reply
不是，盒子没有底面的吗？那怎么装纸巾呢？
The designer has replied
1
Reply
Box just slides into bottom
0
Reply
Print Profile
Multicolor Cube Upside Down with PETG Supports- 0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
Multicolor Cube Upside Down with PETG Supports- 0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld