This adapter will allow you to wind your 5" Schacht shuttle bobbins on any modern cordless drill.
Print it on its side with a flat side down, and no supports are required. Low to medium infill. It's designed so that it'll have maximum strength when printed on a flat side.
It might work with other bobbins up to 7" in length with a 7.85mm internal diameter as well, though those longer bobbins will stick off the end of the adapter.
Printer Brand:
LulzBot
Printer:
TAZ 5
Rafts:
No
Supports:
No
Resolution:
0.25mm is fine
Infill:
15% worked for me
Glitter Blue
Notes:
Print on its side, one of the two flat sides. This allows the layers to be continuous along the length of the adapter and maximizes strength.