I needed a sturdy alternative to allow me working on my laptop without a suitable standing desk so I made use of the available handle.
The stand is quite sturdy and can comfortably hold a 16 inch MacBook Pro. While working I rest both my hands on the laptop. I would still add some rubber padding in some places to stop the laptop from unwanted movement. I personally did not have any problems or worries about that so far though.
The attachments are secured by M5 hex screws with a minimal length of about 60 mm. To fasten these I've used these: https://makerworld.com/en/models/33904#profileId-33956
Material & print:
I've started with normal PLA and was already happy, but am now using PLA+ and the extra rigidity seems to work out. I didn't spend to much time tinkering with settings since I don't have much experience yet. I've stay with 15 % infill and 2 walls.
Attributions:
I've used BurgessG's laptop stand to safe some time. You can find the model here: https://www.printables.com/model/255402-update-vertical-laptop-stand-take-3/