First of all, this was just a test if Bambu Labs X1 could do it and o'boy did it do great job. Main thing here is, that the first layer was printed with line width 0.25mm, with 0.4mm nozzle! If you do normal 0.5mm, you loose the details. But in order to succeed, you need to have great plate adhesion and clean filament flow from the nozzle. I printed mine with textured PEI plate. I didn't have any matte red at hand, so the finish is a bit sparkly. I printed 3 of these at the same time, 2 were great but 1 had few flaws if you look really closely. First layer was printed with 50mm/s, other layers with 300mm/s (200mm/s in outer wall).

The multicolor file is 3MF which should give you right colors automaticly in Prusaslicer and in Bambu slicer, but if it doesn't, just paint the whole thing red and color pour the logo as white (30sec job). Printables preview don't seem to show the colors correctly.

If you want to print this with single color printer, use the separate-stl's 1 and 2 and place them on top of each other and turn them together 180 degrees. Then delete the bigger part and slice just the logo. Then undo with ctrl-z and then delete the logo and slice the bigger part. Now you first print the logo with white (don't remove the print from the bed and make sure your bed stays in 50-60 celcius. Then switch to red color and print the second file around (and top of) the logo. Don't use skirt, brim or raft with the white color, but you could use skirt with red colour in order to purge the white.

Cap is designed by @HD_Creator, Nuka Cola logo is from Wikimedia commons.

Note! These are not valid currency in real world, only ingame! Next Fallout is in development!

No supports.

1st layer line width 0.25mm, rest 0.4-0.5mm.

No Brim!

edit 22.12.2022: I added Printables cap as a bonus!