Since I also print with resin and don't have a suitable small waste garbage can at my place,

I created this container which can be screwed under the desk.

It consists of 2 parts for the pull-out frame,

one guide each for the right and left which are screwed under the desk and the waste garbage can.

As the pull-out frame does not fit on the printer as a whole,

it consists of 2 parts which are glued together.

The frame is designed so that it can only be glued together correctly (2 lugs and a radius on the top edge determine the position).

When everything is assembled,

you can push the frame into the guide from the rear and insert the container from above.

2 stoppers at the rear prevent the frame from being pulled out completely to the front.