REMOVE BEFORE FLIGHT tag keychain replica
REMOVE BEFORE FLIGHT tag keychain replica
Boost
77
134
26
Print Profile(2)
Four tags, 0.2mm layer, 2 walls, 15% infill
Designer
2.3 h
1 plate
One Tag, 0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Boost
77
134
26
0
175
117
Released
Description
An exact replica of the REMOVE BFORE FLIGHT tags often found on airplanes and fighter jets. Printable in multicolor only
Comment & Rating (26)
All
Print Profile
One Tag, 0.2mm layer, 2 walls, 15% infill
I scaled it down to 75% and it printed great!
1
Reply
Print Profile
One Tag, 0.2mm layer, 2 walls, 15% infill
Perfect 👍🏻
0
Reply
Print Profile
One Tag, 0.2mm layer, 2 walls, 15% infill
Great multicolour print, as with all such prints though, a lot of waste is generated.
0
Reply
Printed in Red, White and Silver Bambu PLA Basic. Nice clean print, I especially like the way the three colours merge into each other seamlessly on the bottom layer. I haven't done much in the way of multicolour, but this is nice. Lots of waste (poop!) in my bucket. (see 3rd picture) 👍
0
Reply
Print Profile
One Tag, 0.2mm layer, 2 walls, 15% infill
très bon fichier ! le rendu est super
0
Reply
Print Profile
Four tags, 0.2mm layer, 2 walls, 15% infill
Nice model✈️
0
Reply
Print Profile
One Tag, 0.2mm layer, 2 walls, 15% infill
Topp
0
Reply
Print Profile
Four tags, 0.2mm layer, 2 walls, 15% infill
parfait 👌 merci pour le partage 🙏
0
Reply
Print Profile
One Tag, 0.2mm layer, 2 walls, 15% infill
Printed perfect, was able to set the purge profile to 0.5 with no bleed through.
0
Reply
Print Profile
Four tags, 0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld