A1 Bowden Tube Removal Tool Tool by Northern Printworks

Northern Printworks

3D Printer>3D Printer Accessories

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 30% infill

Designer

11 min

1 plate

4.8(101)

Boost

173

387

112

811

509

Released

Description

A simple little addition to add to the top of your A1/A1 Mini toolhead to allow easier removal of the Bowden tubes on hotend side if you have an AMS. These little suckers are difficult to get pressed with fingers so this tool allows you to press towards what corner you want then wiggle the tube to come out. The holes are large enough to not interfere with the Bowden tubes and toolhead movements. Check my other prints to find the A1 Bowden tube supports and the release tool for the AMS side of the A1/A1 Mini.

How to use:
Place your thumb under the toolhead (Make sure not hot), then use your other 2 fingers to press straight down on the releaser. Then simply use your other hand to wiggle the tube out.

A1 Bowden Tube Supports:

https://makerworld.com/en/models/78732#profileId-83046

A1 Bowden Tube Release Tool AMS Side:
https://makerworld.com/en/models/78741#profileId-83050

Comment & Rating (112)

@3DaFull

Print Profile

0.2mm layer, 2 walls, 30% infill

great job!

@Lew_W.

Upside down

(Edited)

@3DaFull

Replying to @Lew_W. :

Yes, I changed it after the photo, hehe

@Thepitbull21

Print Profile

0.2mm layer, 2 walls, 30% infill

ottimo

(Edited)

@goldiesvinyl

Print Profile

0.2mm layer, 2 walls, 30% infill

fantastic

@Bammer1386

Print Profile

0.2mm layer, 2 walls, 30% infill

Works perfectly, especially as I have big hands.

@lucalentini13

Print Profile

0.2mm layer, 2 walls, 30% infill

Easy to print, it works very well!

@Luca2210

Print Profile

0.2mm layer, 2 walls, 30% infill

easy print

@slowmo

Print Profile

0.2mm layer, 2 walls, 30% infill

hilft beim entfernen der Tubes

(Edited)

@cammi187

Print Profile

0.2mm layer, 2 walls, 30% infill

first print failed. don't know why. but the second print came out good.

@dicosmo.frances

Print Profile

0.2mm layer, 2 walls, 30% infill

I tried three times. The one in the picture is the best result I got, but still not there. However, I guess that it would have been a nice tool.

@jowenx1c

Print Profile

0.2mm layer, 2 walls, 30% infill

nicely printed.

License

This work is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.