Imperial Dragon Illustration (Hueforge)
Imperial Dragon Illustration (Hueforge)
Boost
22
57
7
Print Profile(1)
0.08mm layer, 1 walls, 100% infill
Designer
6.8 h
1 plate
Boost
22
57
7
0
146
16
Released
Description
帝皇之龍 A dragon in the palace
已設定好可以直接打印
All settings are ready.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA PolyLite Red Transmission Distance: 1.5
PLA PolyLite Yellow Transmission Distance: 11
PLA PolyLite White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #2 (0.24mm) swap to Red
At layer #5 (0.48mm) swap to Yellow
At layer #17 (1.44mm) swap to White for the rest.
Comment & Rating (7)
All
Didn't have the same brands of filament but used what I had. Print came out very good. Used your profile settings.
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
I'm dragon in Chinese calendar.
Thanks for this model.
(Edited)
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld