Has failed every single time so far (I've tried more than 5 times)
always halfway through with the supports. tried different materials and different support settings
perhaps splitting the model into 3 parts (2 wings, 1 center seat for the Homepod) might make this much easier as it could eliminate the need for supports entirely
You are printing too fast. You can see in the picture that the middle support is up. Set the speeds to 90mm/s.
Before you start printing, wash the textured pei sheet with hot soapy water so that the filament adheres well.
I uploaded a slow profile. Try to print it and it should work.
Stampa veramente per riuscita dettagli perfetti l’unico neo nella parte dietro non è venuto precisa come si vede da foto per il resto fantastico stampato in PLA CF nero