17 Min Hex Driver Key Chain
Copyright Claim
17 Min Hex Driver Key Chain
Boost
34
44
12
Print Profile(2)
0.2mm layer, 2 walls, 50% infill
Designer
17 min
1 plate
0.2mm layer, 2 walls, 50% infill A1 Mini
19 min
1 plate
Boost
34
44
12
0
68
69
Released
Description
Prints Very Fast Hex Driver Key Chain
I printed it at 50% perfect fit on my hex bits, still could put one in use it and take it out. Shrink it up by 2 or 3 percent if you want it to be permanent.
Comment & Rating (12)
All
Print Profile
0.2mm layer, 2 walls, 50% infill
leider nicht so gut Innensechskant hält nicht beim drehen
The designer has replied
1
Reply
Did you read to "Shrink it up by 2 or 3 percent if you want it to be permanent" above? You may need to adjust it a little to make it work with your bits, print, and or filament. Please try again and redo your review.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
The designer has replied
1
Reply
I hope your enjoy the print! Thanks for the 5 star review!
(Edited)2
Reply
Replying to @MofWI
I do 😊
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
The designer has replied
1
Reply
Glad you like this print and profile, thanks for the star review!
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
The designer has replied
1
Reply
I am glad you like the print, thanks for the five star review.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
The designer has replied
1
Reply
I am glad you like it, thanks for the 5 star review!
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld