Bambu A1 mini Rotary Spool Holder Adapter/ Tentioned holder Adapter V2 Remixed by o.0jack

Remixed by

o.0jack

3D Printer>3D Printer Parts

GIF

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 6 walls, 25% infill

Designer

1.8 h

1 plate

4.9(12)

Boost

156

Released

Description

V2 Stronger

Recommend PETG

Where a full/mostly full spool can unwind due to the gantry movement at the start of a print. The filament gets wrapped around the arm and then causes a jam.so you need tension holder prevent it.

The spring loaded tension holders can be bought separately from the ams, so you have a tentioned holder.

Caution:

After printing, please fold it first to see if it is strong.Bad and wet filament will be weak.

Clean the brim and put some greace on the thread.Will make your installation smoother.

NEED BUY AMS lite Rotary Spool Holder (yellow)

https://store.bambulab.com/collections/accessories-for-a1-mini?page=3

Comment & Rating (17)

@scaramonga

Works fantastic! Thanking you kindly :) Print will fail @ 90-95% on Mini, unless your lucky though? The last few layers really vibrate the machine, aka, the hexagonal part, thus the supports may be not good enough to withstand this, as was my case on first print, as supports are weak. Add 'brim' 10 line to model, select 'strong' tree supports (instead of 'normal'), and increase bed temp to 70, and it will all go great :) No difference in breaking these off, as I have tried both :) Thanks again, as it all works wonderfully x

@CoBrA_RS

Print Profile

0.2mm layer, 6 walls, 25% infill

Fit ok

@19evdominta3

Print Profile

0.2mm layer, 6 walls, 25% infill

Works nicely. While I do have an AMS lite, I'm space-constrained on the mini, so just using this. With that said, I don't have much experience in these spools, but I have managed to pull the Bambu spool adapter off the stand once or twice - probably a user-error, so I now push on the black part + spool to release the spools.

@berryvandenbroe

Print Profile

0.2mm layer, 6 walls, 25% infill

(Edited)

@cosmo_q

Printed with Bambu PLA Tough filament. Feels very strong and looks sleek. I also bought the spoolholder as a replacement which came in two parts. So I did not have to pull the original apart and I could still swap back for incompatible spools. Not sure I will though, this definitely feels like an upgrade.