Happy Jack-o-Lantern Pumpkin created using HueForge.

Printing instructions:

Filament swaps ONLY, no MMU or AMS required, but AMS makes it much easier.

Use Original HueForge profile to get the intended look, my models are very sensitive to print settings because of color blending between layers.
Every setting and filament changes for AMS are carefully prepared and fine-tuned in the Original HueForge print profile, feel free to change colors, but I recommend not to adjust other settings.
If you want to experiment with your own settings or non-original print profiles, for best look print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

You can use same filaments as I did, or you can experiment with your own.

Don't forget to upload a make!

Filaments Used:

• PLA BambuLab Basic Black Transmission Distance: 0.3
• PLA Aurapol Red L-EGO Transmission Distance: 4
• PLA Gratkit Yellow Transmission Distance: 11
• PLA BambuLab Basic Jade White Transmission Distance: 6

Swap Instructions:

• Start with Black
• At layer #7 (0.64mm) swap to Red
• At layer #12 (1.04mm) swap to Yellow
• At layer #21 (1.76mm) swap to White for the rest.