Monkey D Luffy (One Piece) Wanted Poster - Hueforge Print

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

I used a 0.4 nozzle for this print, and it took approximately 12 hours to complete.

It's a large print (250mm x 173mm) so you might need to scale it down if your print bed is a normal 220mm. Remember to untick ‘uniform’ scale if you do this in the slicer, so that your Z height remains unchanged!

Filaments Used:
- PLA Siddament Black Transmission Distance: 0.2
- PLA+ Sunlu Dark Gold Transmission Distance: 1.8
- PLA+ Sunlu Coffee Transmission Distance: 3
- PLA Sunlu Beige Transmission Distance: 8.2
- PLA META Sunlu White Transmission Distance: 9.6

Swap Instructions:

- Start with Black
- At layer #6 (0.36mm) swap to Dark Gold
- At layer #11 (0.56mm) swap to Coffee
- At layer #23 (1.04mm) swap to Beige
- At layer #37 (1.6mm) swap to White for the rest.