Mini Wire Nut / Cap
Copyright Claim
Mini Wire Nut / Cap
Boost
2
1
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
16 min
1 plate
Boost
2
1
5
0
11
31
Released
Description
Overview
These custom wire nuts allow you to waterproof twisted/soldered electrical connections that may be used close to water or outdoors. This low-cost build only requires hot glue or epoxy to seal the connection. These wire nuts were used for an electric bike lighting system.
Materials and Printing
We suggest using TPU, PETG, or PLA for these parts.
- Infill: 15%
- Walls: 2
- Support: Disabled
Assembly
Required materials
- Wire nut
- Hot glue or epoxy
- Begin filling the wire nut cavity with hot glue or epoxy close to full.
- Dip the wire connection into the wire nut cavity and hold to ensure it dries properly.
- All done!
Check out other models
Print-in-place organizer | Print-in-place pill organizer |
 |  |
Valentines Mars rover | AMS and external spool adapter |
 |  |
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Tip Top danke
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This printed well, however I don't quite understand the functional purpose of this part being that it doesn't have any threads. It's too small for my purposes but I suppose if someone needed a small thread less cap, this is the one.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld