Moon Cycles Shelf Series
Boost
50
64
6
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
4.1 h
1 plate
Boost
50
64
6
0
70
38
Released
Description
This series of shelfs is inspired by a member called “omegapoint”.
I've designed it from scratch cause I had to change all of the dimensions and hide the screw holes. This series is designed to be hanged on the wall either by glue or adhesive double tape (I used it) to be as neet as possible.
Also I did ironing on all surfaces but it's not as you would expect it to be. I wanted to mimic the look of a painted wood. You can see it especially on the flat back of the shelfs. It looks like painted, not like plastic.
I'll share my settings.
ENJOY!
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 20% infill
came out perfect. slow print with glow in the dark pla silk. very good no tech notes ⭐️
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Strength Issue:For some reason it printed without any infill…? I’m not sure if that was my error or not, but the outer wall of the model cracked the second i gave it a gentle squeeze to test its strength
The designer has replied
0
Reply
Yes, thats the whole idea to have as little (lightning infill) infill as possible to this kind of project... It's not mean to be squeezed :) It's meant to be light, hang on the wall and display whatever you put there. The reason behind this infill is low material usage. When I choose normal infill it took too much material. I think around 1kg more for 5 shelfs (full set)
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld