Bambu Lab Glue Stick, Bed Adhesive Bottle and Bed Scraper Rack for Honeycomb Storage Wall System
Copyright Claim
Bambu Lab Glue Stick, Bed Adhesive Bottle and Bed Scraper Rack for Honeycomb Storage Wall System
Boost
37
74
16
Print Profile(2)
0.2mm layer, 2 walls, 10% infill, no brim, 2 loop skirt
Designer
1.1 h
1 plate
PLA 0.20mm
53 min
1 plate
Boost
37
74
16
0
164
88
Released
Description
This is basically the same concept as my other glue rack models but I removed two of the bed adhesive bottles and replaced them with a spot for the Bambu Lab bed scraper. It still fits in the same footprint as my other bottle rack, so its an easy swap out if you'd like to change it up.
I've been going through Bambu Lab bed adhesive pretty fast. I had the little boxes stacked up in the corner of my desk and I just wanted to make them a little bit neater. But if you are a normal sane person with only one glue stick and one bottle of bed adhesive, I made a smaller holder just for you.
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 10% infill, no brim, 2 loop skirt
It’s not to fit
The designer has replied
1
Reply
Your scraper appears to be assembled incorrectly.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill, no brim, 2 loop skirt
danke danke sieht sehr schick aus und gut zu drucken
The designer has replied
1
Reply
Vielen Dank! Ich bin froh, dass es dir gefällt!
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill, no brim, 2 loop skirt
nice Print
1
Reply
Print Profile
PLA 0.20mm
Alles bestens.....Danke!
1
Reply
Bamboo scraper does not fit snug. Other than that good print.
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill, no brim, 2 loop skirt
Alles super
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill, no brim, 2 loop skirt
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill, no brim, 2 loop skirt
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill, no brim, 2 loop skirt
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill, no brim, 2 loop skirt
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld